R and P
          Carriages


Home Trailers Parts Rentals Help Section Contact Us
2002 Toyota Tundra (without Tow Package) Brake Controller Installation

Please visit my general install page for overall instructions

I sell brake controllers, so please, if you need one click here! We keep Prodigy P2 Brake Controllers in Stock Regularly!

"Standard" Wire colors to the controller (Tekonsha and others):
- Black, Battery Positive to controller
- White, Negative Ground for Controller
- Blue, Brake feed from controller to Trailer plug at back of truck
- Red, tap into truck Brake light switch signal to tell controller to apply brakes

Remember, the above colors are just a GUIDE. your colors may be different, read the instructions!

 

Installed controller in "pocket" below ignition

2002 Toyota Tundra Brake Controller Install

We removed the lower dash panel (4 x 10mm bolts) to gain access to the brake light switch.
2002 Toyota Tundra Brake Controller
                          Install 2002 Toyota Tundra Brake Controller
                          Install
2002 Toyota Tundra Brake Controller
                          Install  


Under the hood, we drilled a small hole in the side of the fuse box to pass the 12 GA wire through (and sealed with silicone)   the placed a 20 amp circuit breaker in a empty spot. The power feed was connected to the main power stud.
2002 Toyota Tundra Brake Controller
                          Install



We used standard double jacketed high temp 12/2 brake wire in this install.

We used the black wire has 12 volt feed. This brake wire runs both through the firewall to the brake controller, and to the rear of the truck to the trailer plug.

We use a "side tap" to connect the 12 volt power from the circuit breaker to this black wire. This then provides a 12 volt power both to the controller under the dash, and a AUX 12 volt power feed to the plug at the back of the truck ("black" terminal)!

We then used the white wire as the "Blue" wire, as the brake controller output to the plug at the back (we just "pretend" the wire is blue, connecting it to the "blue" plug terminal and the blue wire out the back of the controller) as I do not have double jacked wire that is black and blue wire.
2002 Toyota Tundra Brake Controller
                          Install 2002 Toyota Tundra Brake Controller
                          Install

Remember, this is just a example of how "I" did it.

I don't claim it to be the right way, and your results may differ. It is just free information you to see and how you use it is up to you.

 

 

 

Copyright© R and P Carriages 2015