2007 Jeep
Commander Brake Controller Installation
(Other Years May Be the Same or Similar) Please visit my general install page
for overall instructions "Standard" Wire colors to the controller
(Tekonsha and others):
|
We tapped into the white wire with the tan tracer for the brake light signal (red wire is from the controller) We ran a power feed wire from the 10mm main power stud nut on the fuse panel under the hood, to a 15 amp circuit breaker we mounted in the fuse panel, then out to the firewall. We drilled a small hole in the rubber grommet (and sealed with silicone when done) to pass the power wire into the dash area to power the controller. |