2008 Nissan
Armada Infinity QX56 Brake Controller Installation
Please visit my general install page
for overall instructions - Black, Battery Positive to controller - White, Negative Ground for Controller - Blue, Brake feed from controller to Trailer plug at back of truck - Red, tap into truck Brake light switch signal to tell controller to apply brakes Remember, the above colors are just a GUIDE. your colors may be different, read the instructions! Most Armadas from 2005-2014 come from
the factory pre-wired for a brake controller like this
model did. Below are pictures of the plug we located
under the dash, sort of above the park brake. In this case, installation is as simple as mounting the brake controller in a convenient, easy to reach place, usually under the dash, just above your right leg and connecting the wires from the brake control to the wiring harness and then plugging the harness into the harness located under the dash. On Nissan Titan trucks, with the tow package, the factory provided a plug under the dash to connect the brake controller. On the trucks I have done, it is a plug, located up in the dash, just above park brake, up under the dash. You must have the factory plug harness to plug in. The connector is taped to a wire
harness to the left of the steering column. The easy
way to get to it is to remove the plastic trim below
the steering column. There are two phillip head screws
at the bottom. Remove those and the panel will then
snap off. You can then get to the connector. |